__________________________________________
What separates PFi from the rest? We use only state of the art ASNU test equipment, with additional add on hardware and software specifically designed for testing high flow injectors. This provides some of the most accurate flow data available. We invest heavily in our test equipment to be able to provide you with one of the best products available. All of our injectors are grouped in tightly flow matched sets, and supplied with comprehensive flow and offset data (dead times).
Up for sale is a set of four (4) NEW BOSCH / PFi – 1200cc/min fuel injectors. These injectors have an 11.5mm top o-ring suitable for both OE Nissan and aftermarket 11mm fuel rails. These injectors are plug and play for your factory injector harness (applications listed below).
This set is custom milled from NEW Bosch cores and flow matched to less than +/- 2% (static & dynamic) for optimal idle, and drivability. Fuel discharge is through a single hole with a medium cone spray pattern for superior fuel atomization. These injectors are covered by our best 2yr unlimited mile warranty against electrical and mechanical defects.
Bosch EV14 / PFI injector benefits:
– High impedance – compatible with both OE and aftermarket ECM/ECU injector drivers – removal of OE resistor box required.
– Compatible with all known fuels, including alcohol and E85
– Fast response times, predictable flow down to 2ms, and maintain linear flow up to 8 BAR fuel pressure.
– Great for small-medium displacement engines making big power.
– Will support up to 720bhp @ 90% duty(3bar FP), and over 780bhp at 4bar. (Gasoline)
Applications:
CA18DET:
1987-1988 Silvia S12 RS-X
1989-1990 Nissan Silvia/180SX S13 (International market)
1987-1989 Nissan Bluebird RNU12 SSS ATTESA Limited (Japanese Market)
1989-1994 Nissan 200SX RS13-U Europe.
1985-1990 Nissan Auster “1.8Xtt” and “Euroform Twincam Turbo”
SR20DET:
1990-1994 Nissan Pulsar GTi-R
1990-1994 Nissan Sunny GTi-R
Technical SPECS:
Coil Resistance: 12 Ohms (high-impedance will work with factory ECM/PCM drivers) Removal of factory resistor box necessary for some.
Spray Pattern: medium cone, (single orifice)
Electrical Connector: EV1 / JETRONIC
Fitted with Viton upper and lower o-rings.
Static Flow Rate @ 43.5PSI (300kPa): 114 lb/hr = 14.36g/s = 1200cc/min
Overall Length: 71mm
Dimensions: 53.5mm o-ring seat to seat, 63mm o-ring centerline to centerline
If you have any questions please feel free to ask. We are here to help. Thanks for looking!