1200cc BOSCH EV14 Fuel Injectors Fits Toyota 2JZGTE w/ 11mm Top Feed Fuel Rail

6 – 1200cc Bosch / PFi Fuel Injectors 

2yr Warranty

__________________________________________

What separates PFi from the rest? We use only state of the art ASNU test equipment, with additional add on hardware and software specifically designed for testing high flow injectors. This provides some of the most accurate flow data available. We invest heavily in our test equipment to be able to provide you with one of the best products available. All of our injectors are grouped in tightly flow matched sets, and supplied with comprehensive flow and offset data (dead times).

Up for sale is a set of six (6) NEW BOSCH / PFi – 1200cc/min fuel injectors.  These injectors have an 11.5mm top o-ring suitable for factory Toyota fuel rails, in the applications listed below. These will also fit aftermarket 11mm top feed fuel rails. Also included are the correct EV1/Jetronic Pin-in electrical connectors.

This set is custom milled from NEW Bosch cores and flow matched to less than 2% (static & dynamic) for optimal idle, and drivability. Fuel discharge is through a single hole with a medium cone spray pattern for superior fuel atomization. These injectors are covered by our best 2yr unlimited mile warranty against electrical and mechanical defects.

Bosch EV14 / PFI injector benefits:
– Compatible with all known fuels, including alcohol and E85
– Fast response times, predictable flow down to 2ms, and maintain linear flow up to 8 BAR fuel pressure.
– Great for small-medium displacement engines making big power.
– Will support up to 1000bhp @ 90% duty(3bar FP), and over 1150bhp at 4bar. (Gasoline)

WITH 11mm top feed fuel rail conversion:
– Toyota 2JZGTE (both VVTi, and non) engine, with 11mm top feed fuel rail conversion (not supplied)

Technical SPECS:
Coil Resistance: 12 Ohms (high-impedance, will work with factory ECM/PCM injector drivers) Removal of OE resistor box may be necessary.
Spray Pattern: medium cone, (single orifice)
Electrical Connector: EV1 / JETRONIC
Fitted with Viton upper and lower o-rings.
Static Flow Rate @ 43.5PSI (300kPa): 114 lb/hr = 14.36g/s = 1200cc/min
Overall Length: 71mm
Dimensions: 53.5mm o-ring seat to seat, 63mm o-ring centerline to centerline

If you have any questions please feel free to ask. We are here to help. Thanks for looking!