1200cc Bosch Fuel injectors Vauxhall Opel Astra Calibra Kadett Vectra w/ C20LET

__________________________________________

What separates PFi from the rest? We use only state of the art ASNU test equipment, with additional add on hardware and software specifically designed for testing high flow injectors. This provides some of the most accurate flow data available. We invest heavily in our test equipment to be able to provide you with one of the best products available. All of our injectors are grouped in tightly flow matched sets, and supplied with comprehensive flow and offset data (dead times).

Up for sale is a set of four (4) NEW BOSCH / PFi – 1200cc/min fuel injectors, designed as a direct plug and play replacement for the C20LET applications listed below. 

This set is custom milled from NEW Bosch cores and flow matched to less than +/- 2% (static & dynamic) for optimal idle, and drivability. Fuel discharge is through a single hole with a medium cone spray pattern for superior fuel atomization. These injectors are covered by our best 2yr unlimited mile warranty against electrical and mechanical defects.

Bosch EV14 / PFI injector key benefits:
– High impedance – compatible with both OE and aftermarket ECM/ECU injector drivers.
– Compatible with all known fuels, including alcohol and E85
– Fast response times, predictable flow down to 2ms, and maintain linear flow up to 8 BAR fuel pressure.
– Great for small-medium displacement engines making big power.
– Will support up to 720bhp @ 90% duty(3bar FP), and over 780bhp at 4bar. (Gasoline)

Applications:
– Opel Astra 200t S (C20LET 2.0 turbo engine)
– Opel Calibra A Turbo (C20LET 2.0 turbo engine)
– Opel Kadett 200t S (C20LET 2.0 turbo engine)
– Opel Vectra A Turbo (C20LET 2.0 turbo engine)
– 1992-1995 Vauxhall Cavalier Mark III (C20LET)

Technical SPECS:
Coil Resistance: 12 Ohms (high-impedance will work with factory ECM/PCM drivers)
Spray Pattern: medium cone, (single orifice)
Electrical Connector: EV1 / JETRONIC
Fitted with Viton upper and lower o-rings.
Static Flow Rate @ 43.5PSI (300kPa): 114 lb/hr = 14.36g/s = 1200cc/min
Overall Length: 71mm
Dimensions: 53.5mm o-ring seat to seat, 63mm o-ring centerline to centerline

If you have any questions please feel free to ask. We are here to help. Thanks for looking!